Selleys Liquid Nails Mirror, Metal and Glass

1. Ensure surfaces are sound, dry and free from oil, grease and dust.                                                                                                                                                        
2. Cut cartridge, fit nozzle and cut to size (approximately 5mm), then insert into a caulking gun. Apply using caulking gun.

         Application For Mirrors

1. For mirrors up to 6mm thick, apply strips/beads of adhesive approximately 8cm apart. Do not apply adhesive as ‘blobs/dollops’, or over vinyl backing, or within 5cm of mirrors edge as this may affect product performance or cause discoloration.
2. When mirror is pressed onto the wall strips of adhesive must not spread into, or touch one another. A gap must remain between them.
3. Immediately after applying adhesive place mirror against wall before adhesive skins (within 5 minutes).
4. Support mirror with clips or tape until adhesive develops strength (normally 72 hours).
5. Do not seal around the edges of the mirror for at least a week to allow air circulation.
6. Mirrors should not be fixed directly to unpainted timber, plaster, concrete or brick walls. These surfaces should be painted to prevent potential damage to mirrors.

        General Application

1. Apply as for mirrors and press surfaces together immediately
2. Leave ‘squeeze out’ to cure and trim (avoid cutting into the bond)
3. Support bond until adhesive cures sufficiently (normally 72 hours)

        Limitations

• Not for permanent water immersion.
• Not for repairing broken glass.
• Cannot be painted over.
• Do not use as the sole bonding agent for structural bonding.
• Not suitable for totally enclosed bonds. Adhesive requires air to cure.
• Not re-positionable.
   

• Painted surfaces should not be flaky or peeling. Freshly painted surfaces should be allowed to dry for at least 7 days before job is done. Test compatibility on painted surface before using.
  
• For vinyl backed mirrors, apply adhesive inside vinyl cutouts and not over the vinyl.
  
• Glue lines may be visible through surfaces that are not perfectly opaque.

• Uncured product may be removed with mineral turps.
• Cured product can be removed with Selleys(R) Silicone Remover or by
  mechanical action.